Datapath Vision800 Manual do Utilizador descarregar pdf (Página 10)

Use of the SBC’s onboard graphics adaptor

Onboard Graphics Adaptor used as Control Screen

TheVision800isshippedwiththeBIOSconguredtoboototheonboardVGA.Thisoutputcanthenbe

usedasthecontrolscreenforatypicalwallconguration.

To set the system to boot on the onboard VGA (“Internal Graphics Device” - IGD), enter setup from the

boot screen by pressing <DEL> as prompted.

In the BIOS setup utility select:

Chipset>NorthBridgeConguration>InitiateGraphicAdapter-[IGD]

Chipset>NorthBridgeConguration>PEGPortConguration>PEGPort-[Auto]

CAUTION: If the SBC BIOS is setup for IGD as above, then you must not insert an Image4 or other

VGA graphics card in the rst (x8 lane) PCIe slot.

PleasenotethatwhentheVision800isconguredwithaVision800Xexpansionchassis,therstslotofthe

hostmachineistakenupbytheH-Linkcard,sotheaboveprohibitionreferstotherstslotoftheexpan-

sion chassis.

Onboard Graphics Adaptor Disabled

If you do not require a control screen, then you should disable the integrated graphics as described below.

Connect a VGA monitor to the onboard VGA output and enter setup from the boot screen by pressing

<DEL> as prompted.

In the BIOS setup utility select:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Sem comentários

Datapath Vision800 Manual do Utilizador Página 10